[CaliDude76]

Ok Bro.. check this out... I assume you have a high/low switch like mine.. in the pix.... Also in the pix.. under the column.. all you have to do is take off the plastic half underneath.. the metal plate as well beneath that... and remove the air duct (if you have it there) that feeds air to the lower vent. couple screws.. screwdriver. and maybe a nut-driver depending on what you have down there... after that you expose the column with all the goodies plugged into it.. and then what you do.. is at the same time.. click your high/low turn signal level back over and over.. stick your hand up there, under the column to see and feel for the little rod Caddy was talking about... it's at the bottom.. you'll see the rod clicking a little switch down there.. and presto! the high/low switch..... if you have more ?'s hit me up.. I'll see if i can get you some pix.. when i have better daylight... good luck! Rock On!