|
Re: Hello, my name is jaros44sr and I have a problem...
Quote:
Originally Posted by sinned4me
Do you have to drill out the stud hole, or can you just tap it after you remove the stud. Do you need a bottom tap
on mine you pull out the old stud and mill the top of the stud boss to a certain height. it also depends if you are running guide plates. you then drill the holes on a drill press holding the head at the correct angle, tap the holes, and install the studs with thread sealant (there is coolant behind stud) and your done.
|
Thanks for the info, was kinda hoping to do it on the engine. If that is the case, then I might as well change out to my extra heads
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
|