The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

RustenPaines · 06-10-2010, 11:03 PM

Things never go as fast as you think they should. Finally installed the motor, tranny crossmember. Mocked up the front bags with a 1.5 square tubing spacer. I dont want this thing on the ground just low with a firm ride. The ART setup had 40lbs of air preassure at my desired ride height. Im sure there are other ways to fix that but Porterbuilts front end is a piece I'm proud to display on my truck. Also moched up the steering column. Looks like that will fit. Motor and tranny look really nice with a little paint.

06-10-2010, 11:03 PM	#62
RustenPaines Registered User Join Date: Sep 2008 Location: Portland, Oregon Posts: 286	Re: Torchered Things never go as fast as you think they should. Finally installed the motor, tranny crossmember. Mocked up the front bags with a 1.5 square tubing spacer. I dont want this thing on the ground just low with a firm ride. The ART setup had 40lbs of air preassure at my desired ride height. Im sure there are other ways to fix that but Porterbuilts front end is a piece I'm proud to display on my truck. Also moched up the steering column. Looks like that will fit. Motor and tranny look really nice with a little paint. Attached Images __________________ 69 C10 "Torchered" RC Crawler Nut http://www.dorkstarproductions.com/orcrc.com/forum/ Last edited by RustenPaines; 06-19-2010 at 07:42 PM.