The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

fleetsidelarry · 06-16-2010, 07:13 PM

On 1/2 tons, the u-joint yoke has to come off the rear of the front drive shaft, which means, yeah, the drive shaft has to come out. maybe 3/4 ton is different? be prepared to drip a little tranny fluid when you pull the shaft. its been a while since I've done but its looking like I need to do it again.

06-16-2010, 07:13 PM	#2
fleetsidelarry Senior Car Nut Join Date: Jan 2008 Location: shellman bluff, GA Posts: 1,411	Re: How do i install a carrier bearing? On 1/2 tons, the u-joint yoke has to come off the rear of the front drive shaft, which means, yeah, the drive shaft has to come out. maybe 3/4 ton is different? be prepared to drip a little tranny fluid when you pull the shaft. its been a while since I've done but its looking like I need to do it again. __________________ Larry Last edited by fleetsidelarry; 06-16-2010 at 07:15 PM.