The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

edflores · 06-19-2010, 01:01 PM

I have a lot of questions.
1. Where is the motor suppose to sit with a 350/350? I have a SBC in at the rear holes. It has a 3 speed, but im going to try to change over to an auto. Im not sure about floor clearance.

2. Im gathering the parts for a disk swap. Who has the cheapest 6 lug rotors for the 73-87 spindles? Also, what upper ball joint will i need to put the spindle on?

3. Do i have to put power steering on my truck if i put on disc brakes?

4. Does anyone have a link to where i have to cut the bed to do a shortbed conversion? Frame?

5. Do any OEM 6 lug wheels fit without spacers?
Thanks guys!!!

06-19-2010, 01:01 PM	#1
edflores Registered User Join Date: Jul 2005 Location: Riverside CA Posts: 860	Newb with a 64 I have a lot of questions. 1. Where is the motor suppose to sit with a 350/350? I have a SBC in at the rear holes. It has a 3 speed, but im going to try to change over to an auto. Im not sure about floor clearance. 2. Im gathering the parts for a disk swap. Who has the cheapest 6 lug rotors for the 73-87 spindles? Also, what upper ball joint will i need to put the spindle on? 3. Do i have to put power steering on my truck if i put on disc brakes? 4. Does anyone have a link to where i have to cut the bed to do a shortbed conversion? Frame? 5. Do any OEM 6 lug wheels fit without spacers? Thanks guys!!!