The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Shyguy · 06-28-2010, 06:54 PM

We put a '67 body on a '69 frame, it fit ok. I am still working with a few minor alignment problems with the body.

The problem I had was because I did not know that the back cab rubber mounts are thicker on a three quarter ton. We put a body off of a three quarter ton on a half ton frame using the thicker rear cab rubber mounts from the three quarter ton frame.

Just another mistake I have to correct when I start the restoration on the truck.

06-28-2010, 06:54 PM	#4
Shyguy Junior Member Join Date: Dec 2006 Location: Southeast Missouri Posts: 2,436	Re: Radiator support brackets We put a '67 body on a '69 frame, it fit ok. I am still working with a few minor alignment problems with the body. The problem I had was because I did not know that the back cab rubber mounts are thicker on a three quarter ton. We put a body off of a three quarter ton on a half ton frame using the thicker rear cab rubber mounts from the three quarter ton frame. Just another mistake I have to correct when I start the restoration on the truck. __________________ '67 Chevy C-20 short stepper - build complete, 454/SM-465. '75 C-30 Single Cab DRW-350 small block/NP-435. '77 GMC-6500 Dump Truck, 427 Tall Deck. '92 GMC K-3500 Duallie, 454/4L80E.