We're on a roll now, 3 consecutive nights working on the truck.
Started out by trimming off the last little bit of the floor pan so the new panels could be tacked in. Everything seemed to fall right in place.
Next was cutting and repairing the lower door pillar.
Out with the old.
And in with the new.
We mocked up the outer rocker again and so far so good.
So far these aftermarket panels aren't as bad as I had anticipated them to be. I'm sure my luck will run out though once we hang the repop doors.
I'm rebuilding the door hinges now and ordering some weatherstripping getting ready for the doors.
For those that have rebuilt their door hinges, what do you do on the upper hinges as far as the friction pad and stop goes? Just blast and paint them or can you actually rebuild them?