The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1/2 ton

deek114 · 07-11-2010, 12:15 PM

Ok good thats what I was hoping to hear. Thank you

I think Im going to set the frame next to the truck on the back padio, and pretty much do it piece by piece. The "plan" is to take the front clip off, and move the motor and trans over. Then Take the cab and move it. After the cab is the new bed, and finally the front clip goes on.

Hopefully its as easy as it sounds!

07-11-2010, 12:15 PM	#3
deek114 Registered User Join Date: Jan 2009 Location: decatur, IL. Posts: 162	Re: 1/2 ton - 3/4 ton swap (need advice) Ok good thats what I was hoping to hear. Thank you I think Im going to set the frame next to the truck on the back padio, and pretty much do it piece by piece. The "plan" is to take the front clip off, and move the motor and trans over. Then Take the cab and move it. After the cab is the new bed, and finally the front clip goes on. Hopefully its as easy as it sounds! __________________ Friends don't let friends drive fords.