The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Big Port Jimmy 6 · 07-11-2010, 01:47 PM

Here are a few shots of the rear of my 87 crew with some front belts installed. I have not checked to see if the blind nuts are welded in the cab post. The trim has two knock out buttons in it so maybe the nuts are there. I may have had to use a spacer under the retractor like a washer. I don't remember. I was planning on doing a write up but haven't finished the project, I have been focused on the engine swap instead. Hope this helps Jay

07-11-2010, 01:47 PM	#6
Big Port Jimmy 6 Addicted to Rust Join Date: Dec 2009 Location: Abbeville SC Posts: 1,030	Re: Crew cab rear seat belt? Here are a few shots of the rear of my 87 crew with some front belts installed. I have not checked to see if the blind nuts are welded in the cab post. The trim has two knock out buttons in it so maybe the nuts are there. I may have had to use a spacer under the retractor like a washer. I don't remember. I was planning on doing a write up but haven't finished the project, I have been focused on the engine swap instead. Hope this helps Jay __________________ Current trucks: (48 GMC100 320 inliner) Gone (48 Suburban in pieces) Sold 87 GMC CCSB 5.3 4l60E Daily Driver ECTA National record holder XO/PP We never really grow up, we just learn how to act in public.