The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

nrider · 07-16-2010, 11:26 PM

After reading around the boards on here I found out about POR-15 and decided to try it out on the cab floor and pedal assemblies. Also, when I pulled the carpet there was glue everywhere on the inside of this truck. They even put nails in the carpet which I have never even heard of. These pics are of the cab floor before the POR-15 and after, also of the pedal assemblies before and after. I think it turned out pretty good, oh and since I've never welded and needed to practice with my new welder I built a little weld cart to practice; the last picture is of the cart.
Name: SAM_0355.jpg
Views: 1296
Size: 62.6 KB

Name: SAM_0355.jpg
Views: 1296
Size: 62.6 KB

Name: SAM_0433.jpg
Views: 1296
Size: 80.4 KB

Name: SAM_0413.jpg
Views: 1300
Size: 55.1 KB

Name: SAM_0417.jpg
Views: 1283
Size: 45.3 KB

Name: SAM_0414.jpg
Views: 1271
Size: 49.6 KB

07-16-2010, 11:26 PM	#5
nrider Registered User Join Date: May 2010 Location: Fayetteville, GA Posts: 29	Re: '81 C10 Build Full of Firsts After reading around the boards on here I found out about POR-15 and decided to try it out on the cab floor and pedal assemblies. Also, when I pulled the carpet there was glue everywhere on the inside of this truck. They even put nails in the carpet which I have never even heard of. These pics are of the cab floor before the POR-15 and after, also of the pedal assemblies before and after. I think it turned out pretty good, oh and since I've never welded and needed to practice with my new welder I built a little weld cart to practice; the last picture is of the cart.