The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Longhorn Man · 07-31-2010, 05:51 PM

you'll need to cut a larger hole in the bottom of the dash, figure out the ignition wires, highbeam switch wires, pipers if you go that new. Then the steering shft may need addressed too since it isn't the same as our trucks

07-31-2010, 05:51 PM	#3
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: Tilt steering swap you'll need to cut a larger hole in the bottom of the dash, figure out the ignition wires, highbeam switch wires, pipers if you go that new. Then the steering shft may need addressed too since it isn't the same as our trucks