The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 3 spd man. trans mounts, rubber goes where?

ray_mcavoy · 08-01-2010, 09:47 PM

Each side should have two rubber mounts ... a U-shaped one and a square one.

The U-shaped ones go between the bellhousing and the crossmember. Open end of the "U" facing down (and cupping around) the crossmember.

The square ones go on the underside of the crossmember ... between the crossmember and bolt head.

Those funny looking washer things go directly under the bolt heads. After the bolts are tightened, bend the little "ears" down against the flat sides of the bolt head to keep the bolts from loosening.

08-01-2010, 09:47 PM	#2
ray_mcavoy Registered User Join Date: Nov 2009 Location: Sherman, ME Posts: 2,379	Re: 3 spd man. trans mounts, rubber goes where? Each side should have two rubber mounts ... a U-shaped one and a square one. The U-shaped ones go between the bellhousing and the crossmember. Open end of the "U" facing down (and cupping around) the crossmember. The square ones go on the underside of the crossmember ... between the crossmember and bolt head. Those funny looking washer things go directly under the bolt heads. After the bolts are tightened, bend the little "ears" down against the flat sides of the bolt head to keep the bolts from loosening.