[bill2509]

Its has been a few months, but finally had a chance to get started on body work. Thought I would start with replacing Inner Bed Sides from Mar-K In OKC. Were very easy to install and made a big difference. Forgot about the camera until new bed sides were up to a point where I was going to weld them in, Sorry. The Previous owner at sometime in the trucks life had sprayed about 1/8 inch of undercoat on the entire inside of bed, found out that a 19 wire needle scaler will remove undercoat like crazy with no heat and no damage to the bed side at all. When I start the L/H side I will make sure and take before pictures and after.