[tucsonjwt]

Triangular rear storage shelf was made because the 6 disc CD changer was just screwed to the back of the cab. I made the large right side division the correct size to accomodate the CD changer. I made the top shelf the right size to accomodate a 4' level. On our trucks, you can drill a 1" screw along the top of this shelf to attach it to the truck so it won't move - there is a sheet metal lip hanging down inside just below the rear window - drill anywhere else and you will likely go outside the back wall of the cab. I used 3 screws to hold the shelf in place. The CD changer is attached to the storage shelf with 9/16" self-piercing screws. I use 1/2" oak plywood I had laying around and finished the edges with oak veneer. Had to buy stain and polyurethane to finish it. I would have bought a plastic shelf but I could not see screwing the CD changer to a piece of plastic.