[nyncompute]

Originally Posted by vectorit

Well, my jack is a Sears Craftsman.
Looking at your photo's here, your jack has a shorter lifting surface than mine.
I'd think that's no biggie.
I was thinking of just drilling holes through my lift surfaces, since I don't have those large inner bolts that you have the eye bolts attached to.

Well yea adapt it to what you have for sure. Keep in mind that mine didn't have those large inner bolts. I took off the original nuts and used all thread type couplings to extend the existing bolt stems out like you see there so I could attach the needed pieces. You can see the original nuts in the top pic.