The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**PRattenbury** · 10-09-2010, 08:23 AM

Sort of depends on where the rust is. If it is in inconspicuous places I like Chassis Saver. Just wire brush the crust off and apply it. If the rust is where it can be seen, then the old school sand it down to bare metal, then self-etching primer, then red lead or high-build primer, then sanding again, and top coating would be the ticket. But I am one of those people that would hand that over to a pro. I don't have the patience or talent to get it done right.

10-09-2010, 08:23 AM	#2
PRattenbury Senior Member Join Date: Feb 2010 Location: Maumelle, AR Posts: 478	Re: Rust is no fun. Sort of depends on where the rust is. If it is in inconspicuous places I like Chassis Saver. Just wire brush the crust off and apply it. If the rust is where it can be seen, then the old school sand it down to bare metal, then self-etching primer, then red lead or high-build primer, then sanding again, and top coating would be the ticket. But I am one of those people that would hand that over to a pro. I don't have the patience or talent to get it done right.