|
Re: disk question
The only difference is the 3/4 uses a larger ball-joint. Since it presses in the hole in the 1/2 is too small. The upper just bolts in and is ok. Any '67-87 3/4 lcr would work, I believe. Its just that if you went to say '71-87 I would get the upper to match just so the mounting bushings are all the same.
No one has found a factory 6-bolt that is a direct replacement. The prob. with using those 88-92 (if memory serves) is the distance from the back of the rotor to the inner bearing/seal is different. Thus the rotor does not line up in the caliper.
__________________
I keep two MAGNUMS in my desk. One's a gun, and I keep it loaded. The other's a bottle and it keeps ME loaded. I'm Tracer Bullet. (Calvin and Hobbes)
This life was a test. It was only a test. If this had been an actual life, you would have received instructions on where to go and what to do.
RED meat is not bad for you...FUZZY BLUE/GREEN MEAT is bad for you!!!!!!!!!!!!!
BUILT FORD TOUGH WITH CHEVY STUFF--sticker at Goodguys
|