View Single Post
Old 10-30-2010, 09:11 PM   #5
Sixxer
Registered User
 
Sixxer's Avatar
 
Join Date: Oct 2009
Location: Overland Park, KS
Posts: 70
Re: Rochester Carb Issue

Quote:
Originally Posted by Rich 5150 69 View Post
Then the cable must be sliding thru the lever link or the lever itself is ( I believe is been stamped on the shaft ) and is loosened up and rotating on the shaft, If thats the case you`ll have to remove the plates pull the shaft out and restamp it if possible, or what I have done in the past is if the shaft and lever not to rounded off is to drill out the center of the shaft and tap it and use a machine screw to lock the lever down with a washer and lock ring. the shaft being brass will drill and tap very easily....
That sir, is a damn good idea! I will try that tomorrow morning!
Sixxer is offline   Reply With Quote