View Single Post
Old 11-06-2010, 09:36 AM   #1
MikeB
Senior Member
 
MikeB's Avatar
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,666
Valve in new master cylinder

When I converted my 69 C-10 to front disc brakes 15 years ago, I used a complete GM power brake setup from a 71-72 C-10 -- brackets, pushrod linkage, booster, M/C, and proportioning valve -- that I bought at a junkyard. As I recall, the master cylinder was bad, so I bought one for a 71-72 at a parts store. The brakes have worked well over the years, but the master cylinder and brake lines are crusty rusty, so I've decided to replace them.

I just got a Wagner master cylinder P/N MC80568 which is supposedly a direct OE replacement. However, I noticed it has a spring-loaded device in the rear port. (When I push on it with a drill bit, it springs back.) I assume this is a residual valve, but why would it be there when all the 71-72 trucks came with a proportioning valve? Is the internal valve required? If not, can it be removed?

I haven't removed the old master yet, so can't say whether or not it has the valve.

Thanks for your help here.
__________________
Mike
1969 C10 LWB -- owned for 36 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, recent AAW wiring harness, 5-lug conversion, 1985 spindles and brakes.
1982 C10 SWB -- converted from 250-six to roller cam 350, Vortec heads -- sold
1981 C10 Silverado LWB, 305, TH350C -- sold, but wish I still had it!
1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming.
Retired as a factory automation products salesman.
Worked part-time over the years for an engine builder and a classic car repair shop.
Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then!

Last edited by MikeB; 11-06-2010 at 09:54 AM.
MikeB is offline   Reply With Quote