[Alvin]

I dropped the fuel cell and installed the sending unit for my Stewart-Warner Gauges. While I was under the bed, I installed the ECE rear frame cross member, which leads me to a bit of a problem...

The bumper cannot be installed with the fuel cell bolted in place and the fuel cell can't be installed with the bumper in place. So I think I'm going to have to weld some plates on the bolts for the fuel cell so they won't rotate when tightening. If only I could weld!

I started looking into the wiring under the hood. It's not hacked up too bad, but there are a few interesting add-ons that will need to be removed.

Also, subscribed to the board again so I will be selling some leftover parts to further fund the project. I really need to get her mobile because she's just too heavy to push around now.