The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Jacfourteen · 11-26-2010, 09:11 PM

Not a truck but here is my tahoe, the wheels/tires are 305/40/22 and measure 32" tall by 12.5" wide. They are a little shorter than you mentioned but close. My hoe is sitting at stock height and is a 4WD, there is no real rubbing, but when I back up with the wheels turned tight one of the inner fenders drag on the tire a little. If I screwed the inner flap in a little tighter it wouldn't drag, but just hasn't been important enough for me to mess with. Either that or I could crank the t-bars and it would clear a little bigger tire, but I'm considering going the other way and dropping it. Hope this helps you out!

11-26-2010, 09:11 PM	#5
Jacfourteen Big Red - Now its a SWB! Join Date: Jun 2009 Location: Oroville, Ca Posts: 1,624	Re: Looking for a picture... Not a truck but here is my tahoe, the wheels/tires are 305/40/22 and measure 32" tall by 12.5" wide. They are a little shorter than you mentioned but close. My hoe is sitting at stock height and is a 4WD, there is no real rubbing, but when I back up with the wheels turned tight one of the inner fenders drag on the tire a little. If I screwed the inner flap in a little tighter it wouldn't drag, but just hasn't been important enough for me to mess with. Either that or I could crank the t-bars and it would clear a little bigger tire, but I'm considering going the other way and dropping it. Hope this helps you out! __________________ 68 3/4 ton (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged build thread 41 3/4 ton (wife's)-flatbed, fully restored to original 01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's 02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's