View Single Post
Old 12-04-2010, 08:17 PM   #5
Bugeyev8
Senior Member
 
Bugeyev8's Avatar
 
Join Date: Aug 2009
Location: San Leandro, Ca 94577
Posts: 854
Re: Purchased a Tuned Port Injection L98

the way I did the return was to tap into the tank sending unit and bend a line all the way along the stock pick up, I used stainless saftey wire and wired it to the fuel pick up line and silver soldered it in, been working for all these years, the first time I did it I ran the line in at the top and did not run the line below the fuel level and it caused a constant gas smell in the cab because of the returning fuel, the 2nd way I described works great and no more fuel smell, I used the stock fuel line for the feed to the pump, I am in the middle of cleaning up the TPI install and will be re routing the fuel inlet on the fuel rail to the rear to make the lines easier to route

Quote:
Originally Posted by enick72 View Post
The speed sensor is one of the things I had not thought of. My T5 is sensor output (no cable) so I will be adding a electronic speedo anyway. I also had not thought about a fuel return, can this be done with factory tank/sendin unit?
Bugeyev8 is offline   Reply With Quote