[lmdangerous]

Any chance that you compared the backing plate bolt holes( as in spacing ) between the 3/4 ton spindle and the 1/2 ton spindles?? Did you by chance bolt the caliper bracket to the 3/4 ton spindle??? If it worked then The basic kit( brackets ) will get me going . I have the hub, rotor, and caliper figured out- just have not bought or found the bracket .No one list for a 3/4 ton , but if the 1/2 ton backing plate spacing is the same ( bolt pattern , etc.) then I can use that. and I am good. I have finally located a decent 4.10 chunk - so I am not the slowest on the planet. Nice truck, and nice job on the conversion. I wanna be able to pull my goose neck trailer so I am going to try to hang on to my 1 ton stuff.
LMD