[78cheyenne292]

i had set it a little low because after i rebuilt it it was over flowing then i figured out it was the clip for the needle but i left my float low just to be sure. i have a feeling my fuel pump isnt keeping up and that may be my issue but it worked fine before but maybe i put the wrong filter in. now i set my meter rod to the specs that came with the kit it was a littler higher before do you think if i put it back were it was maybe that will fix my problem?
it may not be a high performance situation but id like to be able to pass slow drivers without my truck sputtering anyways i appreciate i the tips this is my first truck carb rebuild iv only worked on old 2 stroke kawi carbs on my triple.. a little diffrent