The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Chevy51 · 12-07-2010, 09:59 AM

I picked up all the hardware,which was off of the 1/2 ton,and I had to use the straight axle off of the 1/2 ton,the Camaro spindles would not work on the 3/4 ton axle. The pins that hold the spindles on were too small for the 3/4 ton axle. In regards to the back plates, they were already set up for everything. I obtained the parts, and a friend did all the work, so I couldn't help with measurements,Sorry!

12-07-2010, 09:59 AM	#5
Chevy51 Registered User Join Date: Nov 2010 Location: Piqua,Ohio Posts: 58	Re: 1951 Chevy 3/4 Ton Project I picked up all the hardware,which was off of the 1/2 ton,and I had to use the straight axle off of the 1/2 ton,the Camaro spindles would not work on the 3/4 ton axle. The pins that hold the spindles on were too small for the 3/4 ton axle. In regards to the back plates, they were already set up for everything. I obtained the parts, and a friend did all the work, so I couldn't help with measurements,Sorry!