The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

foz · 12-29-2010, 08:44 PM

Hey VA72C10,
I was looking at this thread of yours
http://67-72chevytrucks.com/vboard/s...=404906&page=4
and noticed you used lca's with the ball joint cut off and welded back on in a raised postion for a drop.

any problems running like this? I would think the angle of the pocket would need to be adjusted. Any alignment issues?

12-29-2010, 08:44 PM	#10
foz Registered User Join Date: Jun 2010 Location: Trafalgar, Indiana Posts: 44	Re: Drum drop spindles? Hey VA72C10, I was looking at this thread of yours http://67-72chevytrucks.com/vboard/s...=404906&page=4 and noticed you used lca's with the ball joint cut off and welded back on in a raised postion for a drop. any problems running like this? I would think the angle of the pocket would need to be adjusted. Any alignment issues?