|
Re: Door window channel run
The division bar channel(felt at the front of window,rear of vent) is held in by rivets.I drilled the old ones out only to find that my rivet gun would not fit in the channel.So after a few minutes of haid scritchen',I cut a short piece of 1/8 tubing and put it over the rod of the rivet.It spaced the rivet head out far enough to put it in the bottom of the channel.They've been in there for 5-6 years and never had a problem.The pop rivet pulls itself down into the felt enough to clear the edge of the glass.I lubed mine with silicone and relube it about every 6 months as well as the rubber run up the back and across the top.This keeps the friction down and makes the window easier to roll up/down.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion.
You can't fix stupid,not even with duct tape.
"My appearance is due to the fact that "GOD" does punish you for having too much fun!"
Barrett-Jackson has perfected alchemy,they make rust into gold!
"You can lead a horse to water but you can't saddle a duck"
"Cleverly disguised as a 'Responsible Adult'
"Sometimes your Knight in shining armor is just a retard in tinfoil"
|