The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**slomotion** · 06-27-2003, 03:49 PM

Thanks Da-Burb! Now that I know where to start looking I might make some progress. You're right, the pilot hole is 4 5/8...when I measured the front it was a toss-up as to which dimension to use (4 1/2 or 4 5/8) because there's a lot of paint on these things!

Thanks again

06-27-2003, 03:49 PM	#3
slomotion Old Duffer Join Date: Mar 2003 Location: Maine Posts: 1,823	Thanks Da-Burb! Now that I know where to start looking I might make some progress. You're right, the pilot hole is 4 5/8...when I measured the front it was a toss-up as to which dimension to use (4 1/2 or 4 5/8) because there's a lot of paint on these things! Thanks again __________________ '68 Short C20 Flatbed Dually w/ 292 4bbl, Langdon cast headers, and WC T5 trans. '81 G10 Shorty Van "Good judgement comes from experience, and a lot of that comes from bad judgement." Will Rogers "Under promise, then over achieve."