[Big Fenders]

You removed the bolt that holds in the shaft. Remove the shaft. You will notice a C clip that holds in the axles. One for each axle...remove those and pull axles. Remove spider gears in the carrier assembly and take off the caps that hold the carrier bearings in place. Remove carrier and pay attention to any shims that are next to the carrier bearings...each side. Remove pinion shaft nut and yoke assembly and then you can remove the pinion shaft. This may be more than you want to do but these bearings are set to thousands in tolerances. Would be a good idea to study up on this job before you jump in.
Bob