The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - help-i think i wrecked my hubs

SeventyOne · 01-27-2011, 07:20 PM

According to the Spicer Dana 44 manual:

Torque the inner nut to 50lb/ft, spin the hub to seat the bearing, back off the nut 90* or 1/4 turn maximum, place on lockwasher (tighten inner nut if it won't line up), then torque outer nut to a minimum of 50lb/ft.

I have this as a PDF if anyone needs it.

01-27-2011, 07:20 PM	#15
SeventyOne Registered User Join Date: Mar 2007 Location: Oakland, Ca Posts: 1,382	Re: help-i think i wrecked my hubs According to the Spicer Dana 44 manual: Torque the inner nut to 50lb/ft, spin the hub to seat the bearing, back off the nut 90* or 1/4 turn maximum, place on lockwasher (tighten inner nut if it won't line up), then torque outer nut to a minimum of 50lb/ft. I have this as a PDF if anyone needs it.