|
Re: help-i think i wrecked my hubs
SeventyOne,
Beautiful! that is the exact sequence I recall. I could not find my Hanes manual when I replied first time. An extremely good point in SeventyOne's reply, beyond the need to torque the spindle lock nut....a torque wrench and spindle socket are required to get the proper seating and pre-load on the wheel bearings on the inside nut as well. The booger is always getting the washer seated on the dimple of the inner nut. Keep in mind sometimes flipping it over may help align it with the spindle slot/nut dimple.
JLT
|