The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

tucsonjwt · 01-28-2011, 10:09 AM

87 chevy - how did you get the pin terminals to fit into the connector? Mine seemed to be a molded connector which could not be disassembled. With a broken off piece of old terminal left in the connector, did you pick out the old terminal and broken wires and just force in a new terminal - no solder or other means of attachment, other than brute force? I could not figure out how to do mine so I bought a new harness and connector from AC/Delco.

01-28-2011, 10:09 AM	#4
tucsonjwt Registered User Join Date: Jul 2007 Location: Tucson, AZ Posts: 3,198	Re: Power window Help needed 87 chevy - how did you get the pin terminals to fit into the connector? Mine seemed to be a molded connector which could not be disassembled. With a broken off piece of old terminal left in the connector, did you pick out the old terminal and broken wires and just force in a new terminal - no solder or other means of attachment, other than brute force? I could not figure out how to do mine so I bought a new harness and connector from AC/Delco.