Quote:
Originally Posted by CUSTOM 72
I bought my 3" c-notch pre made, it is a bolt on kit ( very easy and clean install ), i first took my shocks and springs out and rested the frame on the diff, made a center mark on the frame from the center of the diff, marked my pattern on the frame and cut it out with a grinder ( cutting wheel ) Then bolted in the c-notch. took me about 4hrs to do, hope this helps bud 
|
thanks for the help!! sounds easy enough, where did you buy your c-notch? the one i'm looking at is only a 2".
Quote:
Originally Posted by stevencvn72
First, jack the axel to the frame to find where it'll hit so you know where to place your notch. If it's a CPP notch, the instructions aren't always dead on.
Then, I made a cardboard template:
Marked the frame:
Cut...and don't forget to trim some of the spring reinforcing plate so your notch sits flush.:
Refit, mark holes, spend half the day drilling said holes...paint.
and bolt on!
Enjoy!...Actual results may vary.
and don't forget about tool safety!

|

hope with a good bit it won't take so long!

thanks for the help!!