The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Advise on c-notch?

SCOTI · 02-05-2011, 02:27 PM

There's more than one way to successfully complete the task of drilling holes in a frame. I like using unibits when boring large diameter holes (over .500"). I tend to use regular bits on smaller holes.

And yes.... that handle makes it much better on the wrists

.

02-05-2011, 02:27 PM	#21
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 22,143	Re: Advise on c-notch? There's more than one way to successfully complete the task of drilling holes in a frame. I like using unibits when boring large diameter holes (over .500"). I tend to use regular bits on smaller holes. And yes.... that handle makes it much better on the wrists . __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.* Last edited by SCOTI; 02-05-2011 at 02:28 PM.