Here is the factory set up
Cut the holes in the lower four and center upper to fit the Autometer 2 1/16th" gauges
Added a little paint
The speedo and tach backing clamps ,where a tad to short for the sheet metal backing panel so,, I added a little RTV and waa la
The autometer 2 1/16th" gauges fit the lower four spots in the factory panel like they are born there
The factory panel had the highbeam light in a gauge so, had to add one,
sadly the hole is a little off center..
The speedo and tach fit the factory holes "almost" the factory rolled the metal edges, so to close up the hole a little, I unrolled the flange a little , and Waaa la..
The highbeam and turn signal lights are l.e.d.
and the finished panel , only thing missing is the upper three gauges glass,
that is being buffed, then I'll install and have a better pic of the finished product..
