The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Boyd · 02-27-2011, 07:59 PM

Ooh, thanks. I'll definitely be ordering from MB&G.

A couple of related questions....I need to replace 3 of my 4 cab supports, a good sized floor section on the drivers side, and both rockers and cab corners...can I do this with the cab still on the frame as long as I brace everything?

Also, sort of a chicken or the egg question...which piece goes in first? For the drivers side (worst section of the cab) I'll be using the outer floor section that extends 3 or 4 inches into the floor area and has the integrated inner rocker panel. I would assume that I need to:

1. Install the outer floor section

2. Then install the floor section.

3. Then install the front cab supports.

02-27-2011, 07:59 PM	#12
Boyd Resident Lurker Join Date: Apr 2005 Location: Forney, TX Posts: 205	Re: Sheet metal...who to buy from? Ooh, thanks. I'll definitely be ordering from MB&G. A couple of related questions....I need to replace 3 of my 4 cab supports, a good sized floor section on the drivers side, and both rockers and cab corners...can I do this with the cab still on the frame as long as I brace everything? Also, sort of a chicken or the egg question...which piece goes in first? For the drivers side (worst section of the cab) I'll be using the outer floor section that extends 3 or 4 inches into the floor area and has the integrated inner rocker panel. I would assume that I need to: 1. Install the outer floor section 2. Then install the floor section. 3. Then install the front cab supports. __________________ The Rotten Mule: '72 Chevy Short Step Project- http://67-72chevytrucks.com/vboard/s...d.php?t=417252 "Every normal man must be tempted at times to spit on his hands, hoist the black flag, and begin to slit throats."- H.L. Mencken Last edited by Boyd; 02-27-2011 at 08:01 PM.