The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Thadious · 03-01-2011, 01:11 AM

Remove the tilt lever, the screw holding the turn signal lever and it as well, then the hazzard knob. The tin shroud should be worked off at this time (try to avoid bending it, I used a strap wrench (rubber) and just spin it, a little lubricant and it should pop off). Remove the 3 large phillips screws and work the connector out past the lower cone and finally off. It's a pain and real tight.

Good luck!
Ted.

03-01-2011, 01:11 AM	#2
Thadious Registered User Join Date: Sep 2008 Location: Creston, BC Canada Posts: 369	Re: 78 Chevy Van steering column Remove the tilt lever, the screw holding the turn signal lever and it as well, then the hazzard knob. The tin shroud should be worked off at this time (try to avoid bending it, I used a strap wrench (rubber) and just spin it, a little lubricant and it should pop off). Remove the 3 large phillips screws and work the connector out past the lower cone and finally off. It's a pain and real tight. Good luck! Ted. __________________ '51 Chevy Build - In the design stages Aut viam inveniam aut faciam - I will either find a way or make one. If you don't have time to do it right the first time, when will you... My new build - https://67-72chevytrucks.com/vboard/...70#post8958970