The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Cube van too 1/2 suspension interchangeablity

dropd80s · 03-01-2011, 10:01 PM

I haven't done this to a P30 but several times on pickups. Everything should swap over fine on the front but you might double check the rear axle width. I think they measure around 70" and a half ton rear will be narrower than that plus the width you lose running only one rear wheel instead of two. This may not be specifically correct but I would check the rear axle width before you dive in to make sure you can find something to work.

03-01-2011, 10:01 PM	#2
dropd80s Registered User Join Date: Mar 2003 Location: wichita falls tx Posts: 429	Re: Cube van too 1/2 suspension interchangeablity I haven't done this to a P30 but several times on pickups. Everything should swap over fine on the front but you might double check the rear axle width. I think they measure around 70" and a half ton rear will be narrower than that plus the width you lose running only one rear wheel instead of two. This may not be specifically correct but I would check the rear axle width before you dive in to make sure you can find something to work.