The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

dicer · 03-09-2011, 02:50 PM

I have not got that far on mine, but what I plan to do is get some steel and fab a stand that I can roll it on and also tip it over to the front and or the back, and still wheel it around. The same bars will be able to attach to the front or the rear, the only problem with this is I will be using the cab mount points and have to work around the dolly I make. I think the cab weighs about as much as an engine so it shouldn't be too bad to manually flip.

03-09-2011, 02:50 PM	#3
dicer Registered User Join Date: Dec 2010 Location: seattle, wa Posts: 529	Re: How to work on underside of TF cab? I have not got that far on mine, but what I plan to do is get some steel and fab a stand that I can roll it on and also tip it over to the front and or the back, and still wheel it around. The same bars will be able to attach to the front or the rear, the only problem with this is I will be using the cab mount points and have to work around the dolly I make. I think the cab weighs about as much as an engine so it shouldn't be too bad to manually flip.