The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

GhostTown · 04-07-2011, 03:07 PM

I'm no expert. Not at all. You and your friend are likely much more knowledgeable. But, I have shockwaves and a camaro clip with a triangulated 4 bar on my '50. I just thought I'd mention that I wasn't planning on running the shockwaves when we put the clip on, but if I had, I would have welded it in higher on the frame (Z'd it more, if you will) so that I could get the whole thing lower when fully aired out. There isn't as much travel in the shockwaves as I was hoping for. To make up for it I'll need to buy drop spindles, then I should be fine.

Good luck on your build. It's gonna be a nice truck!

04-07-2011, 03:07 PM	#25
GhostTown Registered User Join Date: Feb 2011 Location: Idaho Posts: 305	Re: 57 chevy build I'm no expert. Not at all. You and your friend are likely much more knowledgeable. But, I have shockwaves and a camaro clip with a triangulated 4 bar on my '50. I just thought I'd mention that I wasn't planning on running the shockwaves when we put the clip on, but if I had, I would have welded it in higher on the frame (Z'd it more, if you will) so that I could get the whole thing lower when fully aired out. There isn't as much travel in the shockwaves as I was hoping for. To make up for it I'll need to buy drop spindles, then I should be fine. Good luck on your build. It's gonna be a nice truck! Last edited by GhostTown; 04-07-2011 at 03:08 PM.