The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Windshield Channel

FrankC · 04-11-2011, 03:19 PM

I will post pictures later today or tomorrow. Have one tough spot, Passenger side upper corner.

I need to grind out the channel, POR-15 then prime. Some folks have suggested grinding, treating with POR-15 and then stuff it with JB Weld. I suppose that would work - it is just an epoxy.

If I can put fresh metal in - then I would rather do that.

Time to learn to weld. Would a stitch type welder work from Eastwood?

Frank

04-11-2011, 03:19 PM	#1
FrankC Registered User Join Date: Sep 2001 Location: Raleigh, NC USA Posts: 155	Windshield Channel - Being reproduced or donor? I will post pictures later today or tomorrow. Have one tough spot, Passenger side upper corner. I need to grind out the channel, POR-15 then prime. Some folks have suggested grinding, treating with POR-15 and then stuff it with JB Weld. I suppose that would work - it is just an epoxy. If I can put fresh metal in - then I would rather do that. Time to learn to weld. Would a stitch type welder work from Eastwood? Frank __________________ Thanks, Frank