|
Re: Big Red, my 68 3/4 ton GMC
My bags came in today so I bolted them to the arms to check them out. I still need to slide the crossmember forward about 4" so that the axle sits in the right spot, but I just wanted to play with the bags as this is my first set. Here are some pics:
After that I started cleaning up the rear. I stripped off all the brake hardware and started wirebrushing all the years of grime off the rear. I didn't get it all the way cleaned up but I'm most of the way there. I hope to get some paint on it tomorrow, we'll see how that goes.
__________________
68 3/4 ton  (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged  build thread
41 3/4 ton (wife's)-flatbed, fully restored to original
01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's
02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's
|