The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

suede71 · 07-19-2003, 10:21 AM

Hi.
I am getting excessive wheel hop while backing up in reverse. Could this be a pinion angle problem? I have the two piece drive shaft and my truck is lowered 7 in rear and only 4 in front. If front is slightly higher than rear could this cause pinion probs. The rear is lowered by 5 inch coils and 2 inch blocks. Shocks are at correct angle.

Any ideas???

Thanks,

Tristen

07-19-2003, 10:21 AM	#1
suede71 Registered User Join Date: Jun 2003 Location: Boxford, MA Posts: 50	wheel hop in reverse Hi. I am getting excessive wheel hop while backing up in reverse. Could this be a pinion angle problem? I have the two piece drive shaft and my truck is lowered 7 in rear and only 4 in front. If front is slightly higher than rear could this cause pinion probs. The rear is lowered by 5 inch coils and 2 inch blocks. Shocks are at correct angle. Any ideas??? Thanks, Tristen