The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55 Chevy, Matching upper portion of the cab

dicer · 04-21-2011, 12:21 AM

http://www.eastwood.com/15in-adjusta...ile-gauge.html

Here it is, this way you can mark off sections from front to rear on both sides and
check the profile at those increments, say at .5 to 1 inch increments, you will have to make a whole bunch of card board cut outs and make them fit good to accomplish that. If you put value on your time as I do then this is the ticket. I'm gona get one of these.
And just think of all the other places you can use it too.

04-21-2011, 12:21 AM	#19
dicer Registered User Join Date: Dec 2010 Location: seattle, wa Posts: 529	Re: 55 Chevy, Matching upper portion of the cab http://www.eastwood.com/15in-adjusta...ile-gauge.html Here it is, this way you can mark off sections from front to rear on both sides and check the profile at those increments, say at .5 to 1 inch increments, you will have to make a whole bunch of card board cut outs and make them fit good to accomplish that. If you put value on your time as I do then this is the ticket. I'm gona get one of these. And just think of all the other places you can use it too. Last edited by dicer; 04-21-2011 at 12:23 AM.