Here's a shot at the R/F tee fitting....Located behind the crossmember under the frame rail:
-
-
Disconnect the rear line...and plug the tee...then install a union on the rear line....
-
-
-
-
Now, it's time to begin the bending. You will need a good quality bender to bend the lines. The black sharpie marks are guide marks used by me in conjuction with my bender. It has markings on the handle that you transfer to the tube, in order to determine where to start the bend.....Now start bending !!!
-
-
-
-
-
-
-