[67c10rustbuket]

Hi there, lets start with the basics, 3 gallon tank is not enough you should use a 5 or 6 gallon, a 3 gallon will have you lifting the front twice then the rear while you wait on the compressor. second the pressure switch is barely if even enough pressure at 120psi. you should use a minimum 110-145 psi switch i like the 175 on the high side. third they say not to use a larger psi switch because the valves cant handle it when in a fs truck with an sbc eng you will likely need around 110 to 120 psi at ride height in the front (only 30 - 50 psi rear). i would use a kit with a higher psi rating and a larger tank personally.
Now for my personal opinion i would not use airbagit.com aka chassistech aka aim industries aka ?? again after my bad experiences with their products but that was 10 years ago so... personally i like to go with brand names with a proven track record like SMC, Parker, Viar but then again its been 10 years since ive used their products.
Any body else have some advice ??