Quote:
Originally Posted by crushermechanic
it is a 71. it turns fine to start and run just not to acc position. i have sprayed it with pb before.
|
I would try wiggling the key up and down a little or pulling it out just a tad while you are turning it. If you can get it to turn to ACC follow the instructions below.
-
Turn the key to the left as far as it will go and insert a straightened paper clip or stiff wire into the hole in the face of the cylinder and “gently” push the spring loaded pin in. Turn the cylinder further to the left to remove it.
After you push the spring loaded pin in with the stiff wire and turn the cylinder further to the left you have to pull the wire out to finish turning it or it will bind. You can also turn it too far after you pull the wire out. That is when you have to wiggle the cylinder back and forth a little bit. If you wiggle it too much the pin will pop back out and you will have to start over. You should not have to put excessive turning pressure on it or push down hard on the spring loaded pin. Gentle and patience are the key words here...
LockDoc