[Altec]

That is awesome! Got a close up of a spot?

Didn't work on my junk any. I cleaned the gutters on my mom's house for her, and inspected a couple spots that need repaired.

I did sit down and did some turbo charger calculating. I figured out a GT35 will give a good solid efficient single turbo setup in the range I'm looking to do for my 6.5L Diesel. I also did some inspecting of other peoples turbo setups and I got my basic pipe routing figured out. I am going to make headers that aim low, and forward with V-Bands. Then I am going to run the pipe so the turbo is on the passenger side in front of the engine with the exhaust outlet aiming back, and the compressor outlet only needing a very small piece of tubing to go to the intercooler. I figure if I do this right if I decide to switch to twins on the 6.5 later, I can hang onto the piping for another project. Turbo 350SB anyone?