Quote:
Originally Posted by 1964c-10
dropped the motor in but havent bolted it down yet due to concerns about header installation
|
You may have the same issue i had here
IF you are referring to the header and clutch linkage concerns. On mine, the down leg of the clutch pivot arm was hitting the rear header tube. I heated the arm right where it is welded to the tube and bent it inside until it cleared the header. Then i got a 3/8" heim joint and threaded that onto the end of my clutch rod so it would all rotate as it should. So far it appears that it will work perfectly. I will try to get some pics of what i did this weekend for ya. I am running headers for a 73-87 truck.