The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

85gmcguy · 05-14-2011, 04:40 PM

I did spindles then went back later and cut one coil. If I did it over I'd do both at the same time. Just be careful on wheel clearance with spindles, trimming lower control arm may be required. On the rear a flip kit is the only way to go IMHO. "C" notch may be optional, depending on how you plan to use the truck. And +1 on the angle grinder (or cut-off wheel). Torch is a no-no.

05-14-2011, 04:40 PM	#8
85gmcguy Plays with trucks Join Date: Sep 2003 Location: Asheville, NC Posts: 433	Re: Question about Ride Height I did spindles then went back later and cut one coil. If I did it over I'd do both at the same time. Just be careful on wheel clearance with spindles, trimming lower control arm may be required. On the rear a flip kit is the only way to go IMHO. "C" notch may be optional, depending on how you plan to use the truck. And +1 on the angle grinder (or cut-off wheel). Torch is a no-no. __________________ Gary My Dad's Old Truck 1985 Last edited by 85gmcguy; 05-14-2011 at 04:41 PM.